Fuji USB-CNV3 PLC Programming Cable
Fuji USB-CNV3-PLC Programming Cable USB-CNV3 Fuji N-series PLC (NB, NJ, NS, NW0) USB programming cable, USB/RS422 interface,3 meters. USB-CNV3 programming cable for Fuji N-series PLCs (NB, NJ, NS, NW0). This cable is used for connecting the PLC (Programmable Logic Controller)
This cable with your Fuji PLC:
- Cable Compatibility: Ensure that the USB-CNV3 cable is compatible with your specific model of Fuji N-series PLC (NB, NJ, NS, NW0). This cable is designed for certain models within the N-series.
- Driver Installation: Before connecting the USB-CNV3 cable to your computer, make sure to install the necessary drivers. These drivers allow your computer to recognize and communicate with the PLC through the USB port.
- Connection Setup:
- Connect the USB-CNV3 cable to your computer’s USB port.
- Connect the other end of the cable to the programming port on your Fuji N-series PLC.
- Software Configuration: You will need programming software to interface with the PLC. Fuji PLCs typically use programming software like Micrex-SX Series SPHinx or other compatible software.
- Programming and Monitoring: Once connected and configured, you can use the programming software to write and upload programs to the PLC, monitor its operation, and perform diagnostics.
